Posted on

how to grow autoflowering cannabis outdoors

G rab either two cotton pads or a paper towel and place some of your seeds (if you have more than one) into it (or between the two cotton pads) . S pray the towel or cotton pads with water so that they are moist. Make sure the temperature is always at about 72 degrees Fahrenheit and stick the seeds and their wrappings under a n upside-down bow l. You could also place them between two plates, or inside a Ziploc bag. The seeds will crack open in a few days, and you can then plant them in the soil. Be careful not to tear or damage root tips that may extend, as they can sometimes entangle in the paper or cotton fibers.

It starts with germination . This is when the little plants pop out of their shells when given a bit of water. Germinating autoflower seeds is the same process as germinating other kinds of seeds. The differences come a little bit later. There are a few methods for germinating your seeds. You can put the seed directly in the soil, you can soak it in water until it cracks open, you can use a wet paper towel or cotton pad to do the job, or you can soak your seed in water then plant it in a peat moss jiffy pellet, which is the method we recommend.

Drop your seeds into water and leave them there. Let them remain for 24-48 hours , lo ng enough for the roots to start showing . This should take less than a week for the whole process overall. The water should be 65 degrees Fahrenheit and kept relatively fresh by changing it every other day or so . You can plant the seeds whenever you like after they’ve cracked open , just make sure to continue to keep the soil moist (but not wet), especially if you plant them on the earlier side. Be sure not to touch any exposed root tips with bare hands. Use a clean spoon to relocate and plant the seed. This method is riskier because fragile root tips can get damaged, and seeds can become water logged and drown if left in water too long.

The paper towel or cotton pad germination method

This low-maintenance method keeps the roots protected from the very start. Simply make a small hole in the soil with a pencil, put the seed in the hole, and cover it over. Get the soil moist by spraying it with water, and keep the temperature at 72 degrees Fahrenheit. Keep the soil moist, and in less than a week , you should see some green popping up out.

When you grow outdoor marijuana plants, y ou’ll want to grow them in a predictable, safe environment. Since the elements outside are not always predictable, starting your baby plants indoors is the best way to go. Young marijuana plants – whether they’re autoflowers or the more regular photosensitive plants – are alwa y s vulnerable in their first stages . This is especially true when going from a seed to a young seedling. Gardeners who coddle their baby plants a little bit are usually better off later in their plants’ lifetimes as well. G iving your grow season a healthy start is the best way to ensure you grow healthy plants that produce plenty of weed in the end.

Germination

This is the method we recommend for customers at a Pot for Pot. Soak your seed in a glass of neutral pH (or bottled) water for 12-24 hours, but do not exceed 24 hours. If a root tip pops out, do not touch it with bare hands. Instead, use a clean spoon to move your seed. After soaking your seed, expand your jiffy pellet by soaking it in neutral pH (or bottled) water for about 10-15 minutes or until fully expanded. Drain excess water, then plant your soaked seed about one knuckle (1 cm) down into the pellet, being sure to cover it with pellet soil so the seed is in darkness. Keep your pellet moist but not wet, give it 2-7 days, and you should see green sprouting above the surface.

Since you’re planning to grow your autoflower plant(s) outside, it’s a good idea to get the plant gradually used to the outdoor conditions without shocking it. This is best done if the temperature outside is consistently warm enough (always above 40 degrees Fahrenheit), and it can take just a few days. Start by keeping your plant outside for just 3 hours, and make sure that outside spot isn’t too exposed. Gradually increase the amount of time, day by day, until you have reached 24 hours. At that point , your plant will be ready for constant exposure to the elements without getting a shock that could affect its health and yield.

This article has been viewed 11,899 times.

This article was co-authored by wikiHow staff writer, Hannah Madden. Hannah Madden is a writer, editor, and artist currently living in Portland, Oregon. In 2018, she graduated from Portland State University with a B.S. in Environmental Studies. Hannah enjoys writing articles about conservation, sustainability, and eco-friendly products. When she isn’t writing, you can find Hannah working on hand embroidery projects and listening to music.

If you’re new to marijuana growing, autoflower seeds are a great choice. These cannabis seeds don’t require a rigorous light schedule, and they’re more forgiving when it comes to temperature fluctuations and fungus control. They also grow much faster than typical cannabis seeds, so you can get a full yield in just 8 to 12 weeks! We’ve answered your questions about autoflowering seeds so you can pick the right strain for you.

How to grow autoflowering cannabis outdoors

For example, California gets an average of 14:30hrs of sunlight in the summer 1 and around 9:40hs in the winter, so you should plan your growing cycle according to where you live.

If you wish to grow a specific strain that grows tall, you should grow them in smaller pots or train them so they can’t be seen by people walking by or from other balconies. You can also build a structure similar to a hoop house around your plants, by covering them with a plastic sheet you can keep the rain off, reduce light like most outdoor growers do with the light deprivation technique, and have more stealth cannabis grow.

Temperate climates

In colder climates plants tend to slow down their rate of growth, so you will usually use less nutrients. Also have in mind that in the winter the humidity levels are lower, so you’ll want to water sporadically so your plant has time to absorb the nutrients. Have in mind that if the temperature is below 4°C, water can freeze the roots, so it’s better to feed your plant when the temperatures are higher.

If you’re starting to grow cannabis just now, you probably are wondering When to plant? Well, this will depend on the expected weather and all the things that come with it. There are 6 climate regions in the world, in each one of them the temperature, humidity, and sunlight vary so you should plan according to your environment.

2. Optimal conditions

It’s also a good idea to build a simple structure to help protect your plants from snow and rain, this structure can be built with wooden stakes and a plastic sheet and will ensure your plants don’t freeze or get mold.